diff --git a/README.md b/README.md
index e4a90b9..1d39550 100644
--- a/README.md
+++ b/README.md
@@ -432,7 +432,6 @@
 can process normally if needed.
 
 
-
 ## Update 6-3-2021: Very Old Film
 
 Since this was first written, I've done a fair bit of testing using low
@@ -455,6 +454,32 @@
   better film speed than the Pyrocat-HD negs.
 
 
+## Update 8-29-2021 Very VERY Old Film
+
+* I wanted to try some ancient film this way. So, I shot some sheets
+  of 2x3 Kodak Super-XX (expired 1/1961).  That's right, this film has
+  been out of date for over *60 years*.  I used both Pyrocat-HD
+  1.5:1:200 and D-23 1:1 to seminstand process a couple of these
+  negatives.
+
+  The results?  Perfectly printable negatives.  The Pyrocat produced a
+  bit more negative fog, but noticably less visible grain.  The D-23
+  produced a "cleaner" negative, but had a lot more grain.  It's worth
+  noting that Super-XX was always a rather grainy film and was pretty
+  much replaced by Tri-X in short order, particularly for smaller
+  formats.  Both developers produced the full box ASA 200.
+
+  Unsurprisingly, there were non-development artifacts due to the
+  physical deterioration of the film.  The sheets were stuck together
+  a bit in the box and I did see some mottling on the non-emulsion
+  side of the film. This resulted in some spots in the final negative.
+
+  All-in-all this demonstrates several things.  First of all,
+  "reasonably" out-of-date film can pretty much be used as if it were
+  new.  Secondly, semistand processing may offer a path for rescuing
+  "found" old films.
+
+
 ## Copyright And Use
 
 All content here is Copyright (c) 2021 TundraWare Inc., Des Plaines, IL USA